FAG HSS71910-E-T-P4S Bearing

FAG HSS71910-E-T-P4S spindle bearings | 50x72x12mm

Also known as : HSS71910-E-T-P4S

• Inside Diameter: 50 mm
• Outside Diameter: 72 mm
• Width: 12 mm
• Basic dynamic load rating: 9.4 kN
• Basic static load rating: 6.1 kN

Inquire Now

FAG HSS71910-E-T-P4S Bearing

Number	HSS71910-E-T-P4S
Type	FAG spindle bearings adjusted, in pairs or sets, contact angle a = 25°, lip seals on both sides, non-contact, restricted tolerances
d	50 mm
D	72 mm
B	12 mm
a	20,2 mm
Da	67,5 mm	Tolerance: H12
da	55 mm	Tolerance: h12
r1 min	0,6 mm
ra max	0,6 mm
ra1 max	0,15 mm
rmin	0,6 mm
α	25 °	Contact angle
m	0,15 kg	≈ Mass
Cr	9400 N	Basic dynamic load rating, radial
C0r	6100 N	Basic static load rating, radial
Cur	630 N	Fatigue limit load, radial
nG Fett	24000 1/min	Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings.
FV L	56 N	Preload force
FV M	169 N	Preload force
FV H	338 N	Preload force
KaE L	163 N	Lift-off force
KaE M	497 N	Lift-off force
KaE H	1014 N	Lift-off force
ca L	81,7 N/µm	Axial rigidity
ca M	122 N/µm	Axial rigidity
ca H	159 N/µm	Axial rigidity

Nodes bearings have FAG HSS71910-E-T-P4S spindle bearings in stock, FAG bearings, precision spindle bearings, adjusted, in pairs or sets, contact angle α = 25°, lip seals on both sides, non-contact, restricted tolerances.