TIMKEN 11162-11300-B tapered bearings with Flange
Also known as : 11162-11300-B
- Inside Diameter: 41.275 mm
- Outside Diameter: 76.2 mm
- Width: 7.292 mm
- Basic dynamic load rating: 48.1 kN
- Basic static load rating: 55.1 kN
TIMKEN 11162-11300-B Bearing
TIMKEN 11162-11300-B Bearing details
| Series | 11000 |
|---|---|
| model | 11162-11300-B |
| Cone Part Number | 11162 |
| Cup Part Number | 11300-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
0.700 Kg 1.60 lb |
| Dimensions | |
| d - Bore |
41.275 mm 1.6250 in |
| D - Cup Outer Diameter |
76.2 mm 3 in |
| D1 - Flange Outer Diameter |
80.863 mm 3.1836 in |
| B - Cone Width |
17.384 mm 0.6844 in |
| C - Cup Width |
14.288 mm 0.5625 in |
| C1 - Cup Flange Width |
3.571 mm 0.1406 in |
| T - Bearing Width to Flange |
7.292 mm 0.2871 in |
| T1 - Bearing Width |
18.009 mm 0.7090 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
1.5 mm 0.06 in |
| r - Cup Backface "To Clear" Radius |
1.5 mm 0.06 in |
| da - Cone Frontface Backing Diameter |
46.5 mm 1.83 in |
| db - Cone Backface Backing Diameter |
49 mm 1.93 in |
| Da - Cup Frontface Backing Diameter |
73.90 mm 2.91 in |
| Ab - Cage-Cone Frontface Clearance |
2.3 mm 0.09 in |
| Aa - Cage-Cone Backface Clearance |
1 mm 0.04 in |
| a - Effective Center Location |
-0.8 mm -0.03 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
12500 N 2800 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
48100 N 10800 lbf |
| C0 - Static Radial Rating |
55100 N 12400 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
10400 N 2340 lbf |
| Factors | |
| K - Factor | 1.2 |
| e - ISO Factor | 0.49 |
| Y - ISO Factor | 1.23 |
| G1 - Heat Generation Factor (Roller-Raceway) | 19.2 |
| G2 - Heat Generation Factor (Rib-Roller End) | 12.8 |
| Cg - Geometry Factor | 0.0735 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 11162-11300-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
