TIMKEN 17119-17244-B Bearing

TIMKEN 17119-17244-B tapered bearings with Flange

Also known as : 17119-17244-B

• Inside Diameter: 30.163 mm
• Outside Diameter: 61.999 mm
• Width: 5.271 mm
• Basic dynamic load rating: 43.2 kN
• Basic static load rating: 44.1 kN

Inquire Now

TIMKEN 17119-17244-B Bearing

Series	17000
model	17119-17244-B
Cone Part Number	17119
Cup Part Number	17244-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.300 Kg 0.70 lb
Dimensions
d - Bore	30.163 mm 1.1875 in
D - Cup Outer Diameter	61.999 mm 2.4409 in
D1 - Flange Outer Diameter	65.862 mm 2.5930 in
B - Cone Width	16.566 mm 0.6522 in
C - Cup Width	14.288 mm 0.5625 in
C1 - Cup Flange Width	3.556 mm 0.1400 in
T - Bearing Width to Flange	5.271 mm 0.2075 in
T1 - Bearing Width	16.002 mm 0.6300 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	1.5 mm 0.06 in
r - Cup Backface "To Clear" Radius	1.5 mm 0.06 in
da - Cone Frontface Backing Diameter	34.5 mm 1.36 in
db - Cone Backface Backing Diameter	37.10 mm 1.46 in
Da - Cup Frontface Backing Diameter	58.93 mm 2.34 in
Ab - Cage-Cone Frontface Clearance	2.5 mm 0.1 in
Aa - Cage-Cone Backface Clearance	-0.5 mm -0.02 in
a - Effective Center Location	-3.6 mm -0.14 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	11200 N 2520 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	43200 N 9720 lbf
C0 - Static Radial Rating	44100 N 9910 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	7340 N 1650 lbf
Factors
K - Factor	1.53
e - ISO Factor	0.38
Y - ISO Factor	1.57
G1 - Heat Generation Factor (Roller-Raceway)	11.8
G2 - Heat Generation Factor (Rib-Roller End)	7.49
Cg - Geometry Factor	0.0579

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 17119-17244-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.