TIMKEN 2796-2720-B tapered bearings with Flange
Also known as : 2796-2720-B
- Inside Diameter: 34.925 mm
- Outside Diameter: 76.2 mm
- Width: 11.113 mm
- Basic dynamic load rating: 86.9 kN
- Basic static load rating: 102 kN
TIMKEN 2796-2720-B Bearing
TIMKEN 2796-2720-B Bearing details
| Series | 2700 |
|---|---|
| model | 2796-2720-B |
| Cone Part Number | 2796 |
| Cup Part Number | 2720-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
0.600 Kg 1.30 lb |
| Dimensions | |
| d - Bore |
34.925 mm 1.3750 in |
| D - Cup Outer Diameter |
76.2 mm 3 in |
| D1 - Flange Outer Diameter |
82.550 mm 3.2500 in |
| B - Cone Width |
25.654 mm 1.0100 in |
| C - Cup Width |
19.050 mm 0.7500 in |
| C1 - Cup Flange Width |
6.350 mm 0.2500 in |
| T - Bearing Width to Flange |
11.113 mm 0.4375 in |
| T1 - Bearing Width |
23.813 mm 0.9375 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
40.90 mm 1.61 in |
| db - Cone Backface Backing Diameter |
47.5 mm 1.87 in |
| Da - Cup Frontface Backing Diameter |
73.90 mm 2.91 in |
| Ab - Cage-Cone Frontface Clearance |
1.5 mm 0.06 in |
| Aa - Cage-Cone Backface Clearance |
1 mm 0.04 in |
| a - Effective Center Location |
-8.1 mm -0.32 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
22500 N 5060 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
86900 N 19500 lbf |
| C0 - Static Radial Rating |
102000 N 23000 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
11700 N 2630 lbf |
| Factors | |
| K - Factor | 1.93 |
| e - ISO Factor | 0.3 |
| Y - ISO Factor | 1.98 |
| G1 - Heat Generation Factor (Roller-Raceway) | 28.7 |
| G2 - Heat Generation Factor (Rib-Roller End) | 12.2 |
| Cg - Geometry Factor | 0.0725 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 2796-2720-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
