TIMKEN 3382-3320-B Bearing

TIMKEN 3382-3320-B tapered bearings with Flange

Also known as : 3382-3320-B

• Inside Diameter: 39.688 mm
• Outside Diameter: 80.167 mm
• Width: 10.32 mm
• Basic dynamic load rating: 115 kN
• Basic static load rating: 129 kN

Inquire Now

TIMKEN 3382-3320-B Bearing

Series	3300
model	3382-3320-B
Cone Part Number	3382
Cup Part Number	3320-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	1.000 Kg 2.10 lb
Dimensions
d - Bore	39.688 mm 1.5625 in
D - Cup Outer Diameter	80.167 mm 3.1562 in
D1 - Flange Outer Diameter	84.826 mm 3.3396 in
B - Cone Width	30.391 mm 1.1965 in
C - Cup Width	23.813 mm 0.9375 in
C1 - Cup Flange Width	4.763 mm 0.1875 in
T - Bearing Width to Flange	10.320 mm 0.4063 in
T1 - Bearing Width	29.370 mm 1.1563 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	3.30 mm 0.130 in
da - Cone Frontface Backing Diameter	45.5 mm 1.79 in
db - Cone Backface Backing Diameter	52.1 mm 2.05 in
Da - Cup Frontface Backing Diameter	77.47 mm 3.05 in
Ab - Cage-Cone Frontface Clearance	1.8 mm 0.07 in
Aa - Cage-Cone Backface Clearance	1.5 mm 0.06 in
a - Effective Center Location	-10.9 mm -0.43 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	29800 N 6700 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	115000 N 25800 lbf
C0 - Static Radial Rating	129000 N 29100 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	13900 N 3130 lbf
Factors
K - Factor	2.14
e - ISO Factor	0.27
Y - ISO Factor	2.2
G1 - Heat Generation Factor (Roller-Raceway)	34.6
G2 - Heat Generation Factor (Rib-Roller End)	12.1
Cg - Geometry Factor	0.0744

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 3382-3320-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.