TIMKEN 33895-33820-B Bearing

TIMKEN 33895-33820-B tapered bearings with Flange

Also known as : 33895-33820-B

• Inside Diameter: 53.975 mm
• Outside Diameter: 93.264 mm
• Width: 10.32 mm
• Basic dynamic load rating: 130 kN
• Basic static load rating: 161 kN

Inquire Now

TIMKEN 33895-33820-B Bearing

Series	33800
model	33895-33820-B
Cone Part Number	33895
Cup Part Number	33820-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.900 Kg 2.00 lb
Dimensions
d - Bore	53.975 mm 2.1250 in
D - Cup Outer Diameter	93.264 mm 3.6718 in
D1 - Flange Outer Diameter	97.937 mm 3.8558 in
B - Cone Width	28.575 mm 1.1250 in
C - Cup Width	22.225 mm 0.8750 in
C1 - Cup Flange Width	4.763 mm 0.1875 in
T - Bearing Width to Flange	10.320 mm 0.4063 in
T1 - Bearing Width	27.783 mm 1.0938 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	1.5 mm 0.06 in
r - Cup Backface "To Clear" Radius	0.80 mm 0.030 in
da - Cone Frontface Backing Diameter	59.90 mm 2.36 in
db - Cone Backface Backing Diameter	63 mm 2.48 in
Da - Cup Frontface Backing Diameter	90.93 mm 3.62 in
Ab - Cage-Cone Frontface Clearance	2.8 mm 0.11 in
Aa - Cage-Cone Backface Clearance	1 mm 0.04 in
a - Effective Center Location	-7.6 mm -0.3 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	33600 N 7560 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	130000 N 29200 lbf
C0 - Static Radial Rating	161000 N 36200 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	19000 N 4270 lbf
Factors
K - Factor	1.77
e - ISO Factor	0.33
Y - ISO Factor	1.82
G1 - Heat Generation Factor (Roller-Raceway)	52.5
G2 - Heat Generation Factor (Rib-Roller End)	18.5
Cg - Geometry Factor	0.091

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 33895-33820-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.