TIMKEN 339-332-B tapered bearings with Flange
Also known as : 339-332-B
- Inside Diameter: 35.001 mm
- Outside Diameter: 80 mm
- Width: 7.938 mm
- Basic dynamic load rating: 94.3 kN
- Basic static load rating: 83.4 kN
TIMKEN 339-332-B Bearing
TIMKEN 339-332-B Bearing details
| Series | 335 |
|---|---|
| model | 339-332-B |
| Cone Part Number | 339 |
| Cup Part Number | 332-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
0.500 Kg 1.00 lb |
| Dimensions | |
| d - Bore |
35.001 mm 1.3780 in |
| D - Cup Outer Diameter |
80 mm 3.1496 in |
| D1 - Flange Outer Diameter |
84.658 mm 3.3330 in |
| B - Cone Width |
22.403 mm 0.8820 in |
| C - Cup Width |
17.826 mm 0.7018 in |
| C1 - Cup Flange Width |
4.763 mm 0.1875 in |
| T - Bearing Width to Flange |
7.938 mm 0.3125 in |
| T1 - Bearing Width |
21.001 mm 0.8268 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
0.800 mm 0.03 in |
| r - Cup Backface "To Clear" Radius |
0.80 mm 0.030 in |
| da - Cone Frontface Backing Diameter |
41.40 mm 1.63 in |
| db - Cone Backface Backing Diameter |
42.40 mm 1.67 in |
| Da - Cup Frontface Backing Diameter |
77.47 mm 3.05 in |
| Ab - Cage-Cone Frontface Clearance |
1.8 mm 0.07 in |
| Aa - Cage-Cone Backface Clearance |
0 mm 0 in |
| a - Effective Center Location |
-6.4 mm -0.25 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
24400 N 5490 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
94300 N 21200 lbf |
| C0 - Static Radial Rating |
83400 N 18700 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
11400 N 2570 lbf |
| Factors | |
| K - Factor | 2.14 |
| e - ISO Factor | 0.27 |
| Y - ISO Factor | 2.2 |
| G1 - Heat Generation Factor (Roller-Raceway) | 26.5 |
| G2 - Heat Generation Factor (Rib-Roller End) | 13 |
| Cg - Geometry Factor | 0.0676 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 339-332-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
