TIMKEN 369A-362-B Bearing

TIMKEN 369A-362-B tapered bearings with Flange

Also known as : 369A-362-B

• Inside Diameter: 47.625 mm
• Outside Diameter: 90 mm
• Width: 8.887 mm
• Basic dynamic load rating: 102 kN
• Basic static load rating: 95.8 kN

Inquire Now

TIMKEN 369A-362-B Bearing

Series	365
model	369A-362-B
Cone Part Number	369A
Cup Part Number	362-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.600 Kg 1.30 lb
Dimensions
d - Bore	47.625 mm 1.8750 in
D - Cup Outer Diameter	90.000 mm 3.5433 in
D1 - Flange Outer Diameter	94.661 mm 3.7268 in
B - Cone Width	22.225 mm 0.8750 in
C - Cup Width	15.875 mm 0.6250 in
C1 - Cup Flange Width	4.763 mm 0.1875 in
T - Bearing Width to Flange	8.887 mm 0.3499 in
T1 - Bearing Width	20.000 mm 0.7874 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	0.80 mm 0.030 in
da - Cone Frontface Backing Diameter	53.10 mm 2.09 in
db - Cone Backface Backing Diameter	59.90 mm 2.36 in
Da - Cup Frontface Backing Diameter	86.11 mm 3.40 in
Ab - Cage-Cone Frontface Clearance	1.8 mm 0.07 in
Aa - Cage-Cone Backface Clearance	0 mm 0 in
a - Effective Center Location	-4.3 mm -0.17 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	26400 N 5930 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	102000 N 22900 lbf
C0 - Static Radial Rating	95800 N 21500 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	14400 N 3250 lbf
Factors
K - Factor	1.83
e - ISO Factor	0.32
Y - ISO Factor	1.88
G1 - Heat Generation Factor (Roller-Raceway)	33.8
G2 - Heat Generation Factor (Rib-Roller End)	14
Cg - Geometry Factor	0.0773

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 369A-362-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.