TIMKEN 395A-394AB Bearing

TIMKEN 395A-394AB tapered bearings with Flange

Also known as : 395A-394AB

• Inside Diameter: 66.675 mm
• Outside Diameter: 110 mm
• Width: 7.925 mm
• Basic dynamic load rating: 98.9 kN
• Basic static load rating: 125 kN

Inquire Now

TIMKEN 395A-394AB Bearing

Series	395
model	395A-394AB
Cone Part Number	395A
Cup Part Number	394AB
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.800 Kg 1.80 lb
Dimensions
d - Bore	66.675 mm 2.6250 in
D - Cup Outer Diameter	110.000 mm 4.3307 in
D1 - Flange Outer Diameter	114.673 mm 4.5147 in
B - Cone Width	21.996 mm 0.8660 in
C - Cup Width	18.824 mm 0.7411 in
C1 - Cup Flange Width	4.750 mm 0.1870 in
T - Bearing Width to Flange	7.925 mm 0.3120 in
T1 - Bearing Width	21.999 mm 0.8661 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	0.800 mm 0.03 in
r - Cup Backface "To Clear" Radius	1.30 mm 0.050 in
da - Cone Frontface Backing Diameter	72.9 mm 2.87 in
db - Cone Backface Backing Diameter	72.90 mm 2.87 in
Da - Cup Frontface Backing Diameter	105.92 mm 4.18 in
Ab - Cage-Cone Frontface Clearance	2.8 mm 0.11 in
Aa - Cage-Cone Backface Clearance	1.3 mm 0.05 in
a - Effective Center Location	-0.8 mm -0.03 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	25600 N 5760 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	98900 N 22200 lbf
C0 - Static Radial Rating	125000 N 28100 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	17600 N 3970 lbf
Factors
K - Factor	1.45
e - ISO Factor	0.40
Y - ISO Factor	1.49
G1 - Heat Generation Factor (Roller-Raceway)
G2 - Heat Generation Factor (Rib-Roller End)
Cg - Geometry Factor	0.0984

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 395A-394AB bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.