TIMKEN 466-S-453-B tapered bearings with Flange
Also known as : 466-S-453-B
- Inside Diameter: 55.563 mm
- Outside Diameter: 107.95 mm
- Width: 11.113 mm
- Basic dynamic load rating: 161 kN
- Basic static load rating: 166 kN
TIMKEN 466-S-453-B Bearing
TIMKEN 466-S-453-B Bearing details
| Series | 455 |
|---|---|
| model | 466-S-453-B |
| Cone Part Number | 466-S |
| Cup Part Number | 453-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
1.200 Kg 2.60 lb |
| Dimensions | |
| d - Bore |
55.563 mm 2.1875 in |
| D - Cup Outer Diameter |
107.95 mm 4.25 in |
| D1 - Flange Outer Diameter |
113.386 mm 4.4640 in |
| B - Cone Width |
29.317 mm 1.1542 in |
| C - Cup Width |
22.225 mm 0.8750 in |
| C1 - Cup Flange Width |
5.558 mm 0.2188 in |
| T - Bearing Width to Flange |
11.113 mm 0.4375 in |
| T1 - Bearing Width |
27.780 mm 1.0937 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
2.300 mm 0.090 in |
| r - Cup Backface "To Clear" Radius |
0.80 mm 0.030 in |
| da - Cone Frontface Backing Diameter |
62 mm 2.44 in |
| db - Cone Backface Backing Diameter |
66 mm 2.6 in |
| Da - Cup Frontface Backing Diameter |
100.58 mm 3.96 in |
| Ab - Cage-Cone Frontface Clearance |
2 mm 0.08 in |
| Aa - Cage-Cone Backface Clearance |
1.8 mm 0.07 in |
| a - Effective Center Location |
-7.1 mm -0.28 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
41700 N 9370 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
161000 N 36100 lbf |
| C0 - Static Radial Rating |
166000 N 37200 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
23900 N 5380 lbf |
| Factors | |
| K - Factor | 1.74 |
| e - ISO Factor | 0.34 |
| Y - ISO Factor | 1.79 |
| G1 - Heat Generation Factor (Roller-Raceway) | 58.6 |
| G2 - Heat Generation Factor (Rib-Roller End) | 17.1 |
| Cg - Geometry Factor | 0.0946 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 466-S-453-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
TIMKEN bearing cross reference