TIMKEN 546-532-B tapered bearings with Flange
Also known as : 546-532-B
- Inside Diameter: 49.982 mm
- Outside Diameter: 111.125 mm
- Width: 14.288 mm
- Basic dynamic load rating: 172 kN
- Basic static load rating: 206 kN
TIMKEN 546-532-B Bearing
TIMKEN 546-532-B Bearing details
| Series | 535 |
|---|---|
| model | 546-532-B |
| Cone Part Number | 546 |
| Cup Part Number | 532-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
1.800 Kg 3.90 lb |
| Dimensions | |
| d - Bore |
49.982 mm 1.9678 in |
| D - Cup Outer Diameter |
111.125 mm 4.3750 in |
| D1 - Flange Outer Diameter |
117.373 mm 4.6210 in |
| B - Cone Width |
36.957 mm 1.4550 in |
| C - Cup Width |
30.163 mm 1.1875 in |
| C1 - Cup Flange Width |
6.350 mm 0.2500 in |
| T - Bearing Width to Flange |
14.288 mm 0.5625 in |
| T1 - Bearing Width |
38.100 mm 1.5000 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
57.90 mm 2.28 in |
| db - Cone Backface Backing Diameter |
65 mm 2.56 in |
| Da - Cup Frontface Backing Diameter |
100.58 mm 3.96 in |
| Ab - Cage-Cone Frontface Clearance |
1.8 mm 0.07 in |
| Aa - Cage-Cone Backface Clearance |
2 mm 0.08 in |
| a - Effective Center Location |
-12.2 mm -0.48 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
44600 N 10000 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
172000 N 38700 lbf |
| C0 - Static Radial Rating |
206000 N 46200 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
22700 N 5090 lbf |
| Factors | |
| K - Factor | 1.97 |
| e - ISO Factor | 0.3 |
| Y - ISO Factor | 2.02 |
| G1 - Heat Generation Factor (Roller-Raceway) | 64.3 |
| G2 - Heat Generation Factor (Rib-Roller End) | 16.1 |
| Cg - Geometry Factor | 0.0938 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 546-532-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
