TIMKEN 5595-5535-B tapered bearings with Flange
Also known as : 5595-5535-B
- Inside Diameter: 65.883 mm
- Outside Diameter: 122.238 mm
- Width: 13.495 mm
- Basic dynamic load rating: 280 kN
- Basic static load rating: 327 kN
TIMKEN 5595-5535-B Bearing
TIMKEN 5595-5535-B Bearing details
| Series | 5500 |
|---|---|
| model | 5595-5535-B |
| Cone Part Number | 5595 |
| Cup Part Number | 5535-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
2.300 Kg 5.00 lb |
| Dimensions | |
| d - Bore |
65.883 mm 2.5938 in |
| D - Cup Outer Diameter |
122.238 mm 4.8125 in |
| D1 - Flange Outer Diameter |
128.588 mm 5.0625 in |
| B - Cone Width |
43.764 mm 1.7230 in |
| C - Cup Width |
36.513 mm 1.4375 in |
| C1 - Cup Flange Width |
6.350 mm 0.2500 in |
| T - Bearing Width to Flange |
13.495 mm 0.5313 in |
| T1 - Bearing Width |
43.658 mm 1.7188 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
77 mm 3.03 in |
| db - Cone Backface Backing Diameter |
83.10 mm 3.27 in |
| Da - Cup Frontface Backing Diameter |
118.11 mm 4.67 in |
| Ab - Cage-Cone Frontface Clearance |
2 mm 0.08 in |
| Aa - Cage-Cone Backface Clearance |
1.8 mm 0.07 in |
| a - Effective Center Location |
-12.2 mm -0.48 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
72700 N 16300 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
280000 N 63000 lbf |
| C0 - Static Radial Rating |
327000 N 73500 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
44600 N 10000 lbf |
| Factors | |
| K - Factor | 1.63 |
| e - ISO Factor | 0.36 |
| Y - ISO Factor | 1.67 |
| G1 - Heat Generation Factor (Roller-Raceway) | 110 |
| G2 - Heat Generation Factor (Rib-Roller End) | 24.2 |
| Cg - Geometry Factor | 0.0825 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 5595-5535-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
