TIMKEN 594A-592-B tapered bearings with Flange
Also known as : 594A-592-B
- Inside Diameter: 95.25 mm
- Outside Diameter: 152.4 mm
- Width: 15.875 mm
- Basic dynamic load rating: 216 kN
- Basic static load rating: 319 kN
TIMKEN 594A-592-B Bearing
TIMKEN 594A-592-B Bearing details
| Series | 595 |
|---|---|
| model | 594A-592-B |
| Cone Part Number | 594A |
| Cup Part Number | 592-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
2.500 Kg 5.60 lb |
| Dimensions | |
| d - Bore |
95.250 mm 3.7500 in |
| D - Cup Outer Diameter |
152.400 mm 6.0000 in |
| D1 - Flange Outer Diameter |
158.648 mm 6.2460 in |
| B - Cone Width |
36.322 mm 1.4300 in |
| C - Cup Width |
30.163 mm 1.1875 in |
| C1 - Cup Flange Width |
6.350 mm 0.2500 in |
| T - Bearing Width to Flange |
15.875 mm 0.6250 in |
| T1 - Bearing Width |
39.690 mm 1.5626 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
5.100 mm 0.2 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
103.90 mm 4.09 in |
| db - Cone Backface Backing Diameter |
113 mm 4.45 in |
| Da - Cup Frontface Backing Diameter |
144.02 mm 5.71 in |
| Ab - Cage-Cone Frontface Clearance |
2.3 mm 0.09 in |
| Aa - Cage-Cone Backface Clearance |
3.8 mm 0.15 in |
| a - Effective Center Location |
-2.5 mm -0.1 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
56000 N 12600 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
216000 N 48600 lbf |
| C0 - Static Radial Rating |
319000 N 71600 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
42400 N 9530 lbf |
| Factors | |
| K - Factor | 1.32 |
| e - ISO Factor | 0.44 |
| Y - ISO Factor | 1.36 |
| G1 - Heat Generation Factor (Roller-Raceway) | 151 |
| G2 - Heat Generation Factor (Rib-Roller End) | 36.8 |
| Cg - Geometry Factor | 0.142 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 594A-592-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
