TIMKEN 67389-67322-B Bearing

TIMKEN 67389-67322-B tapered bearings with Flange

Also known as : 67389-67322-B

  • Inside Diameter: 130.175 mm
  • Outside Diameter: 196.85 mm
  • Width: 15.083 mm
  • Basic dynamic load rating: 368 kN
  • Basic static load rating: 625 kN

Inquire Now


TIMKEN 67389-67322-B Bearing

TIMKEN 67389-67322-B Bearing details

Series 67300
model 67389-67322-B
Cone Part Number 67389
Cup Part Number 67322-B
Design Units Imperial
Cage Type Stamped Steel
Bearing Weight 5.100 Kg
11.100 lb
Dimensions
d - Bore 130.175 mm
5.1250 in
D - Cup Outer Diameter 196.850 mm
7.7500 in
D1 - Flange Outer Diameter 203.891 mm
8.0272 in
B - Cone Width 46.038 mm
1.8125 in
C - Cup Width 38.100 mm
1.5000 in
C1 - Cup Flange Width 7.145 mm
0.2813 in
T - Bearing Width to Flange 15.083 mm
0.5938 in
T1 - Bearing Width 46.038 mm
1.8125 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius 3.600 mm
0.14 in
r - Cup Backface "To Clear" Radius 3.30 mm
0.130 in
da - Cone Frontface Backing Diameter 141 mm
5.55 in
db - Cone Backface Backing Diameter 147.10 mm
5.79 in
Da - Cup Frontface Backing Diameter 191.01 mm
7.59 in
Ab - Cage-Cone Frontface Clearance 2.3 mm
0.09 in
Aa - Cage-Cone Backface Clearance 3.3 mm
0.13 in
a - Effective Center Location -6.4 mm
-0.25 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions) 95300 N
21400 lbf
C1 - Dynamic Radial Rating (1 million revolutions) 368000 N
82600 lbf
C0 - Static Radial Rating 625000 N
141000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions) 56100 N
12600 lbf
Factors
K - Factor 1.7
e - ISO Factor 0.34
Y - ISO Factor 1.74
G1 - Heat Generation Factor (Roller-Raceway) 384
G2 - Heat Generation Factor (Rib-Roller End) 70.1
Cg - Geometry Factor 0.122

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 67389-67322-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.