TIMKEN 745A-742-B tapered bearings with Flange
Also known as : 745A-742-B
- Inside Diameter: 69.85 mm
- Outside Diameter: 150.089 mm
- Width: 15.875 mm
- Basic dynamic load rating: 377 kN
- Basic static load rating: 417 kN
TIMKEN 745A-742-B Bearing
TIMKEN 745A-742-B Bearing details
| Series | 745 |
|---|---|
| model | 745A-742-B |
| Cone Part Number | 745A |
| Cup Part Number | 742-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
4.000 Kg 8.90 lb |
| Dimensions | |
| d - Bore |
69.850 mm 2.7500 in |
| D - Cup Outer Diameter |
150.089 mm 5.9090 in |
| D1 - Flange Outer Diameter |
157.912 mm 6.2170 in |
| B - Cone Width |
46.673 mm 1.8375 in |
| C - Cup Width |
36.513 mm 1.4375 in |
| C1 - Cup Flange Width |
7.938 mm 0.3125 in |
| T - Bearing Width to Flange |
15.875 mm 0.6250 in |
| T1 - Bearing Width |
44.450 mm 1.7500 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
82 mm 3.23 in |
| db - Cone Backface Backing Diameter |
87.90 mm 3.46 in |
| Da - Cup Frontface Backing Diameter |
143.26 mm 5.64 in |
| Ab - Cage-Cone Frontface Clearance |
2 mm 0.08 in |
| Aa - Cage-Cone Backface Clearance |
1.3 mm 0.05 in |
| a - Effective Center Location |
-11.9 mm -0.47 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
97600 N 21900 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
377000 N 84700 lbf |
| C0 - Static Radial Rating |
417000 N 93800 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
54400 N 12200 lbf |
| Factors | |
| K - Factor | 1.8 |
| e - ISO Factor | 0.33 |
| Y - ISO Factor | 1.84 |
| G1 - Heat Generation Factor (Roller-Raceway) | 160 |
| G2 - Heat Generation Factor (Rib-Roller End) | 26.3 |
| Cg - Geometry Factor | 0.0898 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 745A-742-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
