TIMKEN 93750-93125-B Bearing

TIMKEN 93750-93125-B tapered bearings with Flange

Also known as : 93750-93125-B

  • Inside Diameter: 190.5 mm
  • Outside Diameter: 317.5 mm
  • Width: 28.575 mm
  • Basic dynamic load rating: 731 kN
  • Basic static load rating: 1290 kN

Inquire Now


TIMKEN 93750-93125-B Bearing

TIMKEN 93750-93125-B Bearing details

Series 93000
model 93750-93125-B
Cone Part Number 93750
Cup Part Number 93125-B
Design Units Imperial
Cage Type Stamped Steel
Bearing Weight 20.20 Kg
44.50 lb
Dimensions
d - Bore 190.5 mm
7.5 in
D - Cup Outer Diameter 317.500 mm
12.5000 in
D1 - Flange Outer Diameter 328.524 mm
12.9340 in
B - Cone Width 63.5 mm
2.5 in
C - Cup Width 46.038 mm
1.8125 in
C1 - Cup Flange Width 11.113 mm
0.4375 in
T - Bearing Width to Flange 28.575 mm
1.1250 in
T1 - Bearing Width 63.500 mm
2.5000 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius 4.300 mm
0.170 in
r - Cup Backface "To Clear" Radius 3.30 mm
0.130 in
da - Cone Frontface Backing Diameter 212.10 mm
8.35 in
db - Cone Backface Backing Diameter 217.90 mm
8.58 in
Da - Cup Frontface Backing Diameter 300.70 mm
11.84 in
Ab - Cage-Cone Frontface Clearance 5.3 mm
0.21 in
Aa - Cage-Cone Backface Clearance 8.1 mm
0.32 in
a - Effective Center Location 7.9 mm
0.31 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions) 190000 N
42600 lbf
C1 - Dynamic Radial Rating (1 million revolutions) 731000 N
164000 lbf
C0 - Static Radial Rating 1290000 N
290000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions) 170000 N
38200 lbf
Factors
K - Factor 1.12
e - ISO Factor 0.52
Y - ISO Factor 1.15
G1 - Heat Generation Factor (Roller-Raceway) 912
G2 - Heat Generation Factor (Rib-Roller End) 126
Cg - Geometry Factor 0.146

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 93750-93125-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.