TIMKEN 95500-95925-B tapered bearings with Flange
Also known as : 95500-95925-B
- Inside Diameter: 127 mm
- Outside Diameter: 234.95 mm
- Width: 25.4 mm
- Basic dynamic load rating: 629 kN
- Basic static load rating: 931 kN
TIMKEN 95500-95925-B Bearing
TIMKEN 95500-95925-B Bearing details
| Series | 95000 |
|---|---|
| model | 95500-95925-B |
| Cone Part Number | 95500 |
| Cup Part Number | 95925-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
12.30 Kg 27.100 lb |
| Dimensions | |
| d - Bore |
127 mm 5 in |
| D - Cup Outer Diameter |
234.95 mm 9.25 in |
| D1 - Flange Outer Diameter |
245.958 mm 9.6834 in |
| B - Cone Width |
63.5 mm 2.5 in |
| C - Cup Width |
49.213 mm 1.9375 in |
| C1 - Cup Flange Width |
11.113 mm 0.4375 in |
| T - Bearing Width to Flange |
25.400 mm 1.0000 in |
| T1 - Bearing Width |
63.500 mm 2.5000 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
6.400 mm 0.25 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
142 mm 5.59 in |
| db - Cone Backface Backing Diameter |
153.90 mm 6.06 in |
| Da - Cup Frontface Backing Diameter |
216.92 mm 8.58 in |
| Ab - Cage-Cone Frontface Clearance |
4.8 mm 0.19 in |
| Aa - Cage-Cone Backface Clearance |
5.6 mm 0.22 in |
| a - Effective Center Location |
-14 mm -0.55 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
163000 N 36700 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
629000 N 141000 lbf |
| C0 - Static Radial Rating |
931000 N 209000 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
103000 N 23200 lbf |
| Factors | |
| K - Factor | 1.58 |
| e - ISO Factor | 0.37 |
| Y - ISO Factor | 1.62 |
| G1 - Heat Generation Factor (Roller-Raceway) | 454 |
| G2 - Heat Generation Factor (Rib-Roller End) | 53.8 |
| Cg - Geometry Factor | 0.132 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 95500-95925-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
