TIMKEN HM911244-HM911210-B tapered bearings with Flange
Also known as : HM911244-HM911210-B
- Inside Diameter: 59.987 mm
- Outside Diameter: 130.175 mm
- Width: 16.637 mm
- Basic dynamic load rating: 198 kN
- Basic static load rating: 183 kN
TIMKEN HM911244-HM911210-B Bearing
TIMKEN HM911244-HM911210-B Bearing details
Series | HM911200 |
---|---|
model | HM911244-HM911210-B |
Cone Part Number | HM911244 |
Cup Part Number | HM911210-B |
Design Units | Imperial |
Cage Type | Stamped Steel |
Bearing Weight |
2.100 Kg 4.60 lb |
Dimensions | |
d - Bore |
59.987 mm 2.3617 in |
D - Cup Outer Diameter |
130.175 mm 5.1250 in |
D1 - Flange Outer Diameter |
136.525 mm 5.3750 in |
B - Cone Width |
30.925 mm 1.2175 in |
C - Cup Width |
23.813 mm 0.9375 in |
C1 - Cup Flange Width |
6.350 mm 0.2500 in |
T - Bearing Width to Flange |
16.637 mm 0.6550 in |
T1 - Bearing Width |
34.100 mm 1.3425 in |
Abutment and Fillet Dimensions | |
R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
da - Cone Frontface Backing Diameter |
74.40 mm 2.93 in |
db - Cone Backface Backing Diameter |
84.10 mm 3.31 in |
Da - Cup Frontface Backing Diameter |
123.95 mm 4.88 in |
Ab - Cage-Cone Frontface Clearance |
5.1 mm 0.2 in |
Aa - Cage-Cone Backface Clearance |
3.8 mm 0.15 in |
a - Effective Center Location |
7.9 mm 0.31 in |
Basic Load Ratings | |
C90 - Dynamic Radial Rating (90 million revolutions) |
51200 N 11500 lbf |
C1 - Dynamic Radial Rating (1 million revolutions) |
198000 N 44400 lbf |
C0 - Static Radial Rating |
183000 N 41100 lbf |
Ca90 - Dynamic Thrust Rating (90 million revolutions) |
71900 N 16200 lbf |
Factors | |
K - Factor | 0.71 |
e - ISO Factor | 0.82 |
Y - ISO Factor | 0.73 |
G1 - Heat Generation Factor (Roller-Raceway) | 56.4 |
G2 - Heat Generation Factor (Rib-Roller End) | 16.5 |
Cg - Geometry Factor | 0.0842 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN HM911244-HM911210-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.