TIMKEN LL205449-LL205410-B tapered bearings with Flange
Also known as : LL205449-LL205410-B
- Inside Diameter: 50.8 mm
- Outside Diameter: 77.788 mm
- Width: 5.969 mm
- Basic dynamic load rating: 37.3 kN
- Basic static load rating: 47.2 kN
TIMKEN LL205449-LL205410-B Bearing
TIMKEN LL205449-LL205410-B Bearing details
Series | LL205400 |
---|---|
model | LL205449-LL205410-B |
Cone Part Number | LL205449 |
Cup Part Number | LL205410-B |
Design Units | Imperial |
Cage Type | Stamped Steel |
Bearing Weight |
0.200 Kg 0.50 lb |
Dimensions | |
d - Bore |
50.8 mm 2 in |
D - Cup Outer Diameter |
77.788 mm 3.0625 in |
D1 - Flange Outer Diameter |
80.582 mm 3.1725 in |
B - Cone Width |
12.700 mm 0.5000 in |
C - Cup Width |
9.525 mm 0.3750 in |
C1 - Cup Flange Width |
2.794 mm 0.1100 in |
T - Bearing Width to Flange |
5.969 mm 0.2350 in |
T1 - Bearing Width |
12.700 mm 0.5000 in |
Abutment and Fillet Dimensions | |
R - Cone Backface "To Clear" Radius |
1.5 mm 0.06 in |
r - Cup Backface "To Clear" Radius |
1.5 mm 0.06 in |
da - Cone Frontface Backing Diameter |
55.10 mm 2.17 in |
db - Cone Backface Backing Diameter |
56.90 mm 2.24 in |
Da - Cup Frontface Backing Diameter |
74.93 mm 2.99 in |
Ab - Cage-Cone Frontface Clearance |
2.3 mm 0.09 in |
Aa - Cage-Cone Backface Clearance |
0 mm 0 in |
a - Effective Center Location |
0 mm 0 in |
Basic Load Ratings | |
C90 - Dynamic Radial Rating (90 million revolutions) |
9680 N 2180 lbf |
C1 - Dynamic Radial Rating (1 million revolutions) |
37300 N 8390 lbf |
C0 - Static Radial Rating |
47200 N 10600 lbf |
Ca90 - Dynamic Thrust Rating (90 million revolutions) |
5570 N 1250 lbf |
Factors | |
K - Factor | 1.74 |
e - ISO Factor | 0.34 |
Y - ISO Factor | 1.78 |
G1 - Heat Generation Factor (Roller-Raceway) | 24.2 |
G2 - Heat Generation Factor (Rib-Roller End) | 29.1 |
Cg - Geometry Factor | 0.0699 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN LL205449-LL205410-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.