TIMKEN LM67047-LM67010-B tapered bearings with Flange
Also known as : LM67047-LM67010-B
- Inside Diameter: 31.75 mm
- Outside Diameter: 59.131 mm
- Width: 6.833 mm
- Basic dynamic load rating: 46.7 kN
- Basic static load rating: 44.6 kN
TIMKEN LM67047-LM67010-B Bearing
TIMKEN LM67047-LM67010-B Bearing details
Series | LM67000 |
---|---|
model | LM67047-LM67010-B |
Cone Part Number | LM67047 |
Cup Part Number | LM67010-B |
Design Units | Imperial |
Cage Type | Stamped Steel |
Bearing Weight |
0.200 Kg 0.4 lb |
Dimensions | |
d - Bore |
31.750 mm 1.2500 in |
D - Cup Outer Diameter |
59.131 mm 2.3280 in |
D1 - Flange Outer Diameter |
61.913 mm 2.4375 in |
B - Cone Width |
16.764 mm 0.6600 in |
C - Cup Width |
11.811 mm 0.4650 in |
C1 - Cup Flange Width |
2.769 mm 0.1090 in |
T - Bearing Width to Flange |
6.833 mm 0.2690 in |
T1 - Bearing Width |
15.875 mm 0.6250 in |
Abutment and Fillet Dimensions | |
R - Cone Backface "To Clear" Radius |
2.300 mm 0.090 in |
r - Cup Backface "To Clear" Radius |
1.30 mm 0.050 in |
da - Cone Frontface Backing Diameter |
36.10 mm 1.42 in |
db - Cone Backface Backing Diameter |
39.90 mm 1.57 in |
Da - Cup Frontface Backing Diameter |
57.40 mm 2.26 in |
Ab - Cage-Cone Frontface Clearance |
1.3 mm 0.05 in |
Aa - Cage-Cone Backface Clearance |
0.3 mm 0.01 in |
a - Effective Center Location |
-3 mm -0.12 in |
Basic Load Ratings | |
C90 - Dynamic Radial Rating (90 million revolutions) |
12100 N 2720 lbf |
C1 - Dynamic Radial Rating (1 million revolutions) |
46700 N 10500 lbf |
C0 - Static Radial Rating |
44600 N 10000 lbf |
Ca90 - Dynamic Thrust Rating (90 million revolutions) |
8550 N 1920 lbf |
Factors | |
K - Factor | 1.42 |
e - ISO Factor | 0.41 |
Y - ISO Factor | 1.46 |
G1 - Heat Generation Factor (Roller-Raceway) | 12.8 |
G2 - Heat Generation Factor (Rib-Roller End) | 9.93 |
Cg - Geometry Factor | 0.0612 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN LM67047-LM67010-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.