TIMKEN LM67048-LM67010-BA Bearing

TIMKEN LM67048-LM67010-BA tapered bearings with Flange

Also known as : LM67048-LM67010-BA

• Inside Diameter: 31.75 mm
• Outside Diameter: 58.877 mm
• Width: 6.833 mm
• Basic dynamic load rating: 46.7 kN
• Basic static load rating: 44.6 kN

Inquire Now

TIMKEN LM67048-LM67010-BA Bearing

Series	LM67000
model	LM67048-LM67010-BA
Cone Part Number	LM67048
Cup Part Number	LM67010-BA
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.200 Kg 0.4 lb
Dimensions
d - Bore	31.750 mm 1.2500 in
D - Cup Outer Diameter	58.877 mm 2.3180 in
D1 - Flange Outer Diameter	61.722 mm 2.4300 in
B - Cone Width	16.764 mm 0.6600 in
C - Cup Width	11.811 mm 0.4650 in
C1 - Cup Flange Width	2.769 mm 0.1090 in
T - Bearing Width to Flange	6.833 mm 0.2690 in
T1 - Bearing Width	15.875 mm 0.6250 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	1.30 mm 0.050 in
da - Cone Frontface Backing Diameter	36.10 mm 1.42 in
db - Cone Backface Backing Diameter	42.40 mm 1.67 in
Da - Cup Frontface Backing Diameter	57.40 mm 2.26 in
Ab - Cage-Cone Frontface Clearance	1.3 mm 0.05 in
Aa - Cage-Cone Backface Clearance	0.3 mm 0.01 in
a - Effective Center Location	-3 mm -0.12 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	12100 N 2720 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	46700 N 10500 lbf
C0 - Static Radial Rating	44600 N 10000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	8550 N 1920 lbf
Factors
K - Factor	1.42
e - ISO Factor	0.41
Y - ISO Factor	1.46
G1 - Heat Generation Factor (Roller-Raceway)	12.8
G2 - Heat Generation Factor (Rib-Roller End)	9.93
Cg - Geometry Factor	0.0612

As TIMKEN bearing distributor, Nodes bearings have TIMKEN LM67048-LM67010-BA bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.