TIMKEN LM814849-LM814810-B tapered bearings with Flange
Also known as : LM814849-LM814810-B
- Inside Diameter: 77.788 mm
- Outside Diameter: 117.475 mm
- Width: 11.113 mm
- Basic dynamic load rating: 118 kN
- Basic static load rating: 183 kN
TIMKEN LM814849-LM814810-B Bearing
TIMKEN LM814849-LM814810-B Bearing details
Series | LM814800 |
---|---|
model | LM814849-LM814810-B |
Cone Part Number | LM814849 |
Cup Part Number | LM814810-B |
Design Units | Imperial |
Cage Type | Stamped Steel |
Bearing Weight |
1.000 Kg 2.10 lb |
Dimensions | |
d - Bore |
77.788 mm 3.0625 in |
D - Cup Outer Diameter |
117.475 mm 4.6250 in |
D1 - Flange Outer Diameter |
122.133 mm 4.8084 in |
B - Cone Width |
25.400 mm 1.0000 in |
C - Cup Width |
19.050 mm 0.7500 in |
C1 - Cup Flange Width |
4.763 mm 0.1875 in |
T - Bearing Width to Flange |
11.113 mm 0.4375 in |
T1 - Bearing Width |
25.400 mm 1.0000 in |
Abutment and Fillet Dimensions | |
R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
da - Cone Frontface Backing Diameter |
85.10 mm 3.35 in |
db - Cone Backface Backing Diameter |
90.90 mm 3.58 in |
Da - Cup Frontface Backing Diameter |
116.84 mm 4.60 in |
Ab - Cage-Cone Frontface Clearance |
2.3 mm 0.09 in |
Aa - Cage-Cone Backface Clearance |
2 mm 0.08 in |
a - Effective Center Location |
2.3 mm 0.09 in |
Basic Load Ratings | |
C90 - Dynamic Radial Rating (90 million revolutions) |
30600 N 6870 lbf |
C1 - Dynamic Radial Rating (1 million revolutions) |
118000 N 26500 lbf |
C0 - Static Radial Rating |
183000 N 41200 lbf |
Ca90 - Dynamic Thrust Rating (90 million revolutions) |
26700 N 5990 lbf |
Factors | |
K - Factor | 1.15 |
e - ISO Factor | 0.51 |
Y - ISO Factor | 1.18 |
G1 - Heat Generation Factor (Roller-Raceway) | 88.6 |
G2 - Heat Generation Factor (Rib-Roller End) | 36.6 |
Cg - Geometry Factor | 0.124 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN LM814849-LM814810-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.