FAG HS7003-C-T-P4S spindle bearings | 17x35x10mm
Also known as : HS7003-C-T-P4S
- Inside Diameter: 17 mm
- Outside Diameter: 35 mm
- Width: 10 mm
- Basic dynamic load rating: 3.55 kN
- Basic static load rating: 1.6 kN
FAG HS7003-C-T-P4S Bearing
FAG HS7003-C-T-P4S Bearing details
Number | HS7003-C-T-P4S | |
---|---|---|
Type | FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances | |
d | 17 mm | |
D | 35 mm | |
B | 10 mm | |
a | 8,5 mm | |
Da | 32 mm | Tolerance: H12 |
da | 21 mm | Tolerance: h12 |
Etk max | 24,8 mm | |
Etk min | 24,1 mm | |
Etk1 max | 24,8 mm | |
Etk1 min | 22,9 mm | |
r1 min | 0,3 mm | |
ra max | 0,3 mm | |
ra1 max | 0,1 mm | |
rmin | 0,3 mm | |
α | 15 ° | Contact angle |
m | 0,04 kg | ≈ Mass |
Cr | 3550 N | Basic dynamic load rating, radial |
C0r | 1600 N | Basic static load rating, radial |
Cur | 165 N | Fatigue limit load, radial |
nG Fett | 63000 1/min | Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
nG Öl | 95000 1/min | Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
FV L | 13 N | Preload force |
FV M | 38 N | Preload force |
FV H | 76 N | Preload force |
KaE L | 38 N | Lift-off force |
KaE M | 121 N | Lift-off force |
KaE H | 253 N | Lift-off force |
ca L | 14,3 N/µm | Axial rigidity |
ca M | 22,7 N/µm | Axial rigidity |
ca H | 31,3 N/µm | Axial rigidity |
Nodes bearings have FAG HS7003-C-T-P4S spindle bearings in stock, FAG bearings, precision spindle bearings, adjusted, in pairs or sets, contact angle α = 15°, restricted tolerances.