FAG HSS7005-C-T-P4S spindle bearings | 25x47x12mm
Also known as : HSS7005-C-T-P4S
- Inside Diameter: 25 mm
- Outside Diameter: 47 mm
- Width: 12 mm
- Basic dynamic load rating: 5.8 kN
- Basic static load rating: 2.95 kN
FAG HSS7005-C-T-P4S Bearing
FAG HSS7005-C-T-P4S Bearing details
Number | HSS7005-C-T-P4S | |
---|---|---|
Type | FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, lip seals on both sides, non-contact, restricted tolerances | |
d | 25 mm | |
D | 47 mm | |
B | 12 mm | |
a | 10,8 mm | |
Da | 42 mm | Tolerance: H12 |
da | 30 mm | Tolerance: h12 |
r1 min | 0,6 mm | |
ra max | 0,6 mm | |
ra1 max | 0,3 mm | |
rmin | 0,6 mm | |
α | 15 ° | Contact angle |
m | 0,096 kg | ≈ Mass |
Cr | 5800 N | Basic dynamic load rating, radial |
C0r | 2950 N | Basic static load rating, radial |
Cur | 305 N | Fatigue limit load, radial |
nG Fett | 45000 1/min | Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
FV L | 21 N | Preload force |
FV M | 63 N | Preload force |
FV H | 127 N | Preload force |
KaE L | 64 N | Lift-off force |
KaE M | 201 N | Lift-off force |
KaE H | 419 N | Lift-off force |
ca L | 20,6 N/µm | Axial rigidity |
ca M | 32,7 N/µm | Axial rigidity |
ca H | 45 N/µm | Axial rigidity |
Nodes bearings have FAG HSS7005-C-T-P4S spindle bearings in stock, FAG bearings, precision spindle bearings, adjusted, in pairs or sets, contact angle α = 15°, lip seals on both sides, non-contact, restricted tolerances.