TIMKEN 594-592-B Bearing

TIMKEN 594-592-B tapered bearings with Flange

Also known as : 594-592-B

• Inside Diameter: 95.25 mm
• Outside Diameter: 152.4 mm
• Width: 15.875 mm
• Basic dynamic load rating: 216 kN
• Basic static load rating: 319 kN

Inquire Now

TIMKEN 594-592-B Bearing

Series	595
model	594-592-B
Cone Part Number	594
Cup Part Number	592-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	2.600 Kg 5.60 lb
Dimensions
d - Bore	95.250 mm 3.7500 in
D - Cup Outer Diameter	152.400 mm 6.0000 in
D1 - Flange Outer Diameter	158.648 mm 6.2460 in
B - Cone Width	36.322 mm 1.4300 in
C - Cup Width	30.163 mm 1.1875 in
C1 - Cup Flange Width	6.350 mm 0.2500 in
T - Bearing Width to Flange	15.875 mm 0.6250 in
T1 - Bearing Width	39.688 mm 1.5625 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	3.30 mm 0.130 in
da - Cone Frontface Backing Diameter	103.90 mm 4.09 in
db - Cone Backface Backing Diameter	110 mm 4.33 in
Da - Cup Frontface Backing Diameter	144.02 mm 5.71 in
Ab - Cage-Cone Frontface Clearance	2.3 mm 0.09 in
Aa - Cage-Cone Backface Clearance	3.8 mm 0.15 in
a - Effective Center Location	-2.5 mm -0.1 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	56000 N 12600 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	216000 N 48600 lbf
C0 - Static Radial Rating	319000 N 71600 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	42400 N 9530 lbf
Factors
K - Factor	1.32
e - ISO Factor	0.44
Y - ISO Factor	1.36
G1 - Heat Generation Factor (Roller-Raceway)	151
G2 - Heat Generation Factor (Rib-Roller End)	36.8
Cg - Geometry Factor	0.142

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 594-592-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.