FAG single row angular contact ball bearings are self-retaining units with solid inner and outer rings and ball and cage assemblies with polyamide, sheet metal or brass cages.

FAG single row angular contact ball bearings can support axial forces in one direction and high radial forces. They must be axially adjusted against a second bearing fitted in a mirror image arrangement.

The axial load carrying capacity is dependent on the contact angle; i.e. the larger the angle, the higher the load to which the bearing can be subjected. Due to the contact angle of 40°, these bearings can support high axial loads.

Universal design

FAG single row angular contact ball bearings of universal design have the suffix UA, UL or UO and are intended for fitting in pairs in an X, O or tandem arrangement or fitting in groups. These bearings can be fitted in any arrangement required. For tandem arrangements, pay attention to the guidelines in the section.

The suffix UA indicates small axial internal clearance, the suffix UL indicates slight preload and the suffix UO indicates freedom from clearance in an X or O arrangement.

When ordering FAG bearings, the total quantity of FAG bearings must be stated, not the number of bearing pairs or bearing groups.

Matched FAG bearings

Sets without an intermediate ring are available in an O arrangement (DB), X arrangement (DF) or tandem arrangement (DT).

When ordering FAG bearings, the number of sets must be stated, not the number of single bearings.

Sealing

FAG single row angular contact ball bearings with the suffix 2RS have lip seals on both sides. Contact RS seals are suitable for giving protection against dust, contamination and damp atmospheres.

Lubrication

FAG single row angular contact ball bearings with lip seals on both sides are greased with a high quality grease and are lubricated for life.

Open bearings and bearings with seals on one side are not greased. They can be lubricated with grease or oil.