SKF single row deep groove ball bearings

Nodes bearing supplies SKF single row deep groove ball bearings including metric bearings and inch bearings. SKF single row deep groove ball bearings have deep, uninterrupted raceway grooves. These raceway grooves have a close osculation with the balls, enabling the bearings to accommodate radial loads and axial loads in both directions.

Single row deep groove ball bearings are available open or capped (with seals or shields). Open bearings that are also available capped, may have recesses in the outer ring.

SKF inch bearings in the EE(B), RLS and RMS series are mainly used in the aftermarket and, therefore, SKF recommends not to use these bearings for new bearing arrangement designs.

metric SKF deep groove ball bearings

Dimension standards	Boundary dimensions: ISO 15:2011 Snap rings and grooves: ISO 464:1995
Tolerances	Normal, P6 or P5 SKF Explorer: Dimensional accuracy to P6
Internal clearance	Normal, C2, C3, C4 ranges of standard clearance classes or partitions of adjacent classes.
Misalignment	The permissible angular misalignment between the inner and outer rings depends on the size and internal design of the bearing, the radial internal clearance in operation and the forces and moments acting on the bearing. As a result, only approximate values are listed here. Any misalignment increases bearing noise and reduces bearing service life.

SKF inch deep groove ball bearings

Dimension standards	BS 292-2:1982, withdrawn in 1997
Tolerances	Normal Values: BS 292-2:1982, withdrawn in 1997
Internal clearance	Normal Values: ISO 5753-1:2009 Values are valid for unmounted bearings under zero measuring load.
Misalignment	The permissible angular misalignment between the inner and outer rings depends on the size and internal design of the bearing, the radial internal clearance in operation and the forces and moments acting on the bearing. As a result, only approximate values are listed here. Any misalignment increases bearing noise and reduces bearing service life.